Command Line Reference Guide

Dell#
User
Information
The following describes the show interfaces port-channel brief
command shown in the following example.
Field Description
LAG Lists the port channel number.
Mode Lists the mode:
• L3 — for Layer 3
• L2 — for Layer 2
Status Displays the status of the port channel.
• down — if the port channel is disabled (shutdown)
• up — if the port channel is enabled (no shutdown)
Uptime Displays the age of the port channel in
hours:minutes:seconds.
Ports Lists the interfaces assigned to this port channel.
(untitled) Displays the status of the physical interfaces (up or down).
• In Layer 2 port channels, an * (asterisk) indicates which
interface is the primary port of the port channel. The
primary port sends out interface PDU.
• In Layer 3 port channels, the primary port is not
indicated.
Example
Dell#sh int por 1 br
LAG Mode Status Uptime Ports
1 L2 up 00:00:08 Gi 3/0 (Up) *
Gi 3/1 (Down)
Gi 3/2 (Up)
Dell#
Related
Commands
show lacp — displays the LACP matrix.
show port-channel-flow
Display an egress port in a given port-channel flow.
Z9000
Syntax
show port-channel-flow outgoing-port-channel number incoming-
interface interface {source-ip address destination-ip address}
| {source-port number destination-port number} | {source-mac
address destination-mac address {vlan vlanid | ether-type}}
Interfaces
695