Command Line Reference Guide

Status Definition
Status:
Impedance
Mismatch
There is an impedance mismatch in the cables.
Example
Dell#show tdr gigabitethernet 10/47
Time since last test: 00:00:02
Pair A, Length: OK Status: Terminated
Pair B, Length: 92 (+/- 1) meters, Status: Short
Pair C, Length: 93 (+/- 1) meters, Status: Open
Pair D, Length: 0 (+/- 1) meters, Status: Impedance Mismatch
Related
Commands
tdr-cable-test — runs the TDR test.
UDP Broadcast
The user datagram protocol (UDP) broadcast feature is a software-based method to forward low
throughput (not to exceed 200 pps) IP/UDP broadcast traffic arriving on a physical or VLAN interface.
Important Points to Remember
• This feature is available only on the Z9000 platform.
• Routing information protocol (RIP) is not supported with the UDP Broadcast feature.
• If you configure this feature on an interface using the ip udp-helper udp-port command, the ip
directed-broadcast command becomes ineffective on that interface.
• The existing show interface command has been modified to display the configured broadcast
address.
debug ip udp-helper
Enable UDP debug and display the debug information on a console.
Z9000
Syntax
debug ip udp-helper
To disable debug information, use the no debug ip udp-helper command.
Defaults Debug disabled.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
700
Interfaces