Command Line Reference Guide

Version 9.2(0.2) Introduced on the Z9000, S4810, and S4820T.
Example
Dell#show crypto ipsec transform-set
Transform-Set Name : dallas
Transform-Set refCnt : 0
AH Transform :
ESP Auth Transform :
ESP Encry Transform : 3des
Dell#
show crypto ipsec policy
Display the crypto policy configuration.
Z9000
Syntax
show crypto ipsec policy
Command
Modes
EXEC
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.2) Introduced on the Z9000, S4810, and S4820T.
Example
Dell(conf-crypto-policy)#do show crypto ipsec policy
Policy name : pol1
Policy refcount : 0
Sequence Num : 1
SA Mode : IPSEC-MANUAL
Transform-Set Name :
Peer IP Address :
Inbound AH SPI : 0
Inbound ESP Auth SPI : 0
Inbound ESP Encry SPI : 0
Inbound AH Key : [0]::
Inbound ESP Auth Key : [0]::
Inbound ESP Encry Key : [0]::
Outbound AH SPI : 0
Outbound ESP Auth SPI : 0
Outbound ESP Encry SPI: 0
Outound AH Key : [0]::
Outound ESP Auth Key : [0]::
Outound ESP Encry Key : [0]::
Match sequence Num : 2
Protocol type : tcp
IP or IPv6 : IP
Source address : 1.1.1.1
712
Internet Protocol Security (IPSec)