Command Line Reference Guide

turned off
Dell#
ip address
Assign a primary and secondary IP address to the interface.
Z9000
Syntax
ip address ip-address mask [secondary]
To delete an IP address from an interface, use the no ip address [ip-
address
] command.
Parameters
ip-address Enter an IP address in dotted decimal format.
mask Enter the mask of the IP address in slash prefix format (for
example, /24).
secondary (OPTIONAL) Enter the keyword secondary to designate the
IP address as the secondary address.
Defaults Not configured.
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Usage
Information
You must be in INTERFACE mode before you add an IP address to an interface.
Assign an IP address to an interface prior to entering ROUTER OSPF mode.
IPv4 Routing
731