Command Line Reference Guide

ip proxy-arp
Enable proxy ARP on an interface.
Z9000
Syntax
ip proxy-arp
To disable proxy ARP, use the no ip proxy-arp command.
Defaults Enabled.
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Related
Commands
show ip interface — displays the interface routing status and configuration.
ip route
Assign a static route to the switch.
Z9000
Syntax
ip route ip-address mask {ip-address | interface [ip-address]}
[distance] [permanent] [tag tag-value] [vrf vrf-name]
To delete a specific static route, use the no ip route destination mask
command.
746
IPv4 Routing