Command Line Reference Guide

port-channel-protocol lacp
Enable LACP on any LAN port.
Z9000
Syntax
port-channel-protocol lacp
To disable LACP on a LAN port, use the no port-channel-protocol lacp
command.
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 6.2.1.1 Introduced on the E-Series.
Related
Commands
show lacp — displays the LACP information.
show interfaces port-channel — displays information on configured Port Channel
groups.
show lacp
Display the LACP matrix.
Z9000
Syntax
show lacp port-channel-number [sys-id | counters]
Parameters
port-channel-
number
Enter a port-channel number. The range is from 1 to 128.
sys-id (OPTIONAL) Enter the keywords sys-id and the value that
identifies a system.
counters (OPTIONAL) Enter the keyword counters to display the
LACP counters.
900
Link Aggregation Control Protocol (LACP)