Command Line Reference Guide

clear lldp neighbors
Clear LLDP neighbor information for all interfaces or a specific interface.
Z9000
Syntax
clear lldp neighbors {interface}
Parameters
interface Enter the following keywords and slot/port or number
information:
• For a Fast Ethernet interface, enter the keyword
FastEthernet then the slot/ port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/ port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
tenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Defaults none
Command
Modes
EXEC Privilege
Command
History
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
debug lldp interface
To display timer events, neighbor additions or deletions, and other information about incoming and
outgoing packets, enable LLDP debugging.
Z9000
Syntax
debug lldp interface {interface | all}{events | packet {brief |
detail} {tx | rx | both}}
954
Link Layer Discovery Protocol (LLDP)