Configuration manual

EXEC Privilege mode
cam-acl {default | l2acl number ipv4acl number ipv6acl number ipv4qos number
l2qos number l2pt number ipmacacl number vman-qos | vman-dual-qos number
ecfmacl number ipv4pbr number openflow number | fcoe number iscsioptacl
number
NOTE: If the allocation values are not entered for the CAM regions, the value is 0.
3. Execute the write memory, verify that the new settings will be written to the CAM on the next boot.
EXEC Privilege mode
show cam-acl
4. Reload the system.
EXEC Privilege mode
reload
Test CAM Usage
The test cam-usage command is supported on the Z9000 platform.
Use this command to determine whether sufficient CAM space is available to enable a service-policy.
Create a Class Map with all required ACL rules, then execute the test cam-usage command in Privilege
mode to verify the actual CAM space required. The Status column in the command output indicates
whether or not the policy can be enabled.
Example of the test cam-usage Command
Dell#test cam-usage service-policy input test-cam-usage stack-unit 7 po 0
Stack-Unit | Portpipe | CAM Partition | Available CAM | Estimated CAM per Port
| Status
--------------------------------------------------------------------------------
----------
7 | 0 | IPv4Flow | 192 | 3
| Allowed (64)
Dell#
View CAM Profiles
To view the current CAM profile for the chassis and each component, use the show cam-profile
command.
This command also shows the profile that is loaded after the next chassis or component reload.
Example of the show cam-profile Command
Dell#show cam-profile
-- Chassis CAM Profile --
CamSize : 18-Meg
: Current Settings : Next Boot
Profile Name : Default : Default
L2FIB : 32K entries : 32K entries
L2ACL : 1K entries : 1K entries
IPv4FIB : 256K entries : 256K entries
IPv4ACL : 12K entries : 12K entries
232
Content Addressable Memory (CAM)