Installation Manual
Table Of Contents
- Preface
- The Z9000 System
- Site Preparations
- Install the Z9000
- Power Supplies
- Fans
- Access Ports
- Specifications
- Chassis Physical Design
- Agency Compliance
- USA Federal Communications Commission (FCC) Statement
- Canadian Department of Communication Statement
- European Union EMC Directive Conformance Statement
- Japan: VCCI Compliance for Class A Equipment
- Korean Certification of Compliance
- Safety Standards and Compliance Agency Certifications
- Electromagnetic Compatibility (EMC)
- Product Recycling and Disposal
- Battery Replacement
- For California:
- Technical Support
The Z9000 System | 11
To successfully install the Z9000, ensure that you have the following:
• Z9000 chassis
• Optics (Optics must be ordered separately, they do NOT come with the base system.)
• At least one grounded power source per chassis
• Cable to connect the power source to the chassis (included)
• Mounting brackets for rack installation (included)
• Screws for rack installation (included)
• #1 and #2 Phillips screwdrivers (not supplied)
• Ground cable (not supplied)
• Ground cable screws (not included)
• Universal Serial Bus (USB) cable (included)
• Copper/fiber cables
Other optional components are:
• Solid State Drive (SSD) (included)
• Spare power supply unit
• Spare fan module
• Spare optics
• Breakout cable
Features
The Z9000 offers the following:
• Z9000 CPU and switch processor
• Hot-swappable redundant power supplies
• 19-inch rack-mountable
• Standard 2U chassis height
• Up to 128K MAC address entries supported with hardware assisted aging
• 12K jumbo frames support