Installation Manual
Table Of Contents
- Preface
- The Z9000 System
- Site Preparations
- Install the Z9000
- Power Supplies
- Fans
- Access Ports
- Specifications
- Chassis Physical Design
- Agency Compliance
- USA Federal Communications Commission (FCC) Statement
- Canadian Department of Communication Statement
- European Union EMC Directive Conformance Statement
- Japan: VCCI Compliance for Class A Equipment
- Korean Certification of Compliance
- Safety Standards and Compliance Agency Certifications
- Electromagnetic Compatibility (EMC)
- Product Recycling and Disposal
- Battery Replacement
- For California:
- Technical Support
12 | The Z9000 System
www.dell.com | support.dell.com
Ports
• External serial RS-232 port (RJ45 type)
• Remote management port
• 32-port 40G QSFP+ ports
• USB-A port
• USB-B port
• SSD drive
System Status
You can view the Z9000 status information in several ways, including Light Emitting Diodes (LEDs) and
boot menu options. You can also view status information through the Command Line Interface (CLI)
show commands and with Simple Network Management Protocol (SNMP) traps. For more information
about these options, refer to the FTOS Command Line Reference Guide for the Z9000 System and the
FTOS Configuration Guide for the Z9000 System.
LED Displays
As shown in the following figure, the Z9000 includes LED displays on the I/O side of the chassis. When
the Z9000 powers up or reloads, the PSU LED is solid yellow.
Figure 2-3. System LEDs
SYS
ALM
PSU0
PSU1
LOC
Reset