Installation Manual
Table Of Contents
- Preface
- The Z9000 System
- Site Preparations
- Install the Z9000
- Power Supplies
- Fans
- Access Ports
- Specifications
- Chassis Physical Design
- Agency Compliance
- USA Federal Communications Commission (FCC) Statement
- Canadian Department of Communication Statement
- European Union EMC Directive Conformance Statement
- Japan: VCCI Compliance for Class A Equipment
- Korean Certification of Compliance
- Safety Standards and Compliance Agency Certifications
- Electromagnetic Compatibility (EMC)
- Product Recycling and Disposal
- Battery Replacement
- For California:
- Technical Support
32 | Fans
www.dell.com | support.dell.com
To install a new fan module, follow these steps:
Step Task
1 Twist the latching screws so that the fan screen detaches from the system as shown in the following figure.
2 Remove the screen and set it aside.
3 Take the fan module out of the shipping box.
4 Use the grab handle to slide the module into the bay.
5 Tighten the securing screw on the side of the module.
6 Replace the fan screen.
7 Twist the latching screws to the fan screen until it is securely attached to the system.
Fan screen
PSU1
PSU0
Fan modules
Latching
screw
Latching
screw