Installation Manual
Table Of Contents
- Preface
- The Z9000 System
- Site Preparations
- Install the Z9000
- Power Supplies
- Fans
- Access Ports
- Specifications
- Chassis Physical Design
- Agency Compliance
- USA Federal Communications Commission (FCC) Statement
- Canadian Department of Communication Statement
- European Union EMC Directive Conformance Statement
- Japan: VCCI Compliance for Class A Equipment
- Korean Certification of Compliance
- Safety Standards and Compliance Agency Certifications
- Electromagnetic Compatibility (EMC)
- Product Recycling and Disposal
- Battery Replacement
- For California:
- Technical Support
Fans | 33
Replace a Fan Module
To replace a fan module, follow these steps:
Step Task
1 Twist the latching screws so that the fan screen detaches from the system.
2 Remove the fan screen and set it aside.
3 Loosen the securing screw on the side of the module.
CAUTION: You must complete steps 4 and 5 within one minute or the system will power down.
4 Use the grab handle on the module to slide it out of the bay.
5 Use the grab handle on the replacement module to slide it into the bay.
6 Tighten the captive screw on the module with a screwdriver. Ensure that the module is secure.
7 Replace the fan screen.
8 Twist the latches to the fan screen until it is securely attached to the system.
PSU1
PSU0
Fan Module 0
Fan Module 1
Fan Module 2
Fan Module 3
Screw
Grab Handle