Specifications

Access ports | 35
NOTE: Before starting this procedure, be sure you have a terminal emulation program already installed on
your PC. You will also require appropriate drivers for the USB device in use. Contact Dell Force10 Networks
Technical Support for assistance.
Step Task
1
Power on the PC (XP operating system recommended)
2
Connect the USB-A end of cable into an available USB port on the PC
3
Connect the USB-B end of cable into the USB-B console port on the Z9000
4
Power on the Z9000.
5
Install necessary USB device drivers (internet connection required).
Contact Dell Force10 Networks Technical Support for assistance if necessary.
6
Open your terminal software emulation program to access the Z9000.
7
Using the terminal settings shown here, set the terminal connection settings.
• 9600 baud rate, No parity, 8 data bits, 1 stop bit, No flow control
8
The CLI command prompt appears (shown below) when you are connected to the Z9000.