Command Line Reference Guide

Policy-based Routing (PBR)

Policy-based routing (PBR) allows you to apply routing policies to specific interfaces. To enable PBR,

create a redirect list and apply it to the interface. After the redirect list is applied to the interface, all traffic

passing through the interface is subject to the rules defined in the redirect list. PBR is supported by the

Dell Networking operating software (OS) in MXL platform.

You can apply PBR to physical interfaces and logical interfaces (such as a link aggregation group [LAG] or

virtual local area network [VLAN]). Trace lists and redirect lists do not function correctly when you

configure both in the same configuration.

NOTE: Apply PBR to Layer 3 interfaces only.

description

Add a description to this redirect list.

Syntax

description {description}

To remove the description, use the no description {description}

command.

Parameters

description Enter a description to identify the IP redirect list (80

characters maximum).

Defaults none

Command

Modes

REDIRECT-LIST

Command

History

Version 9.4(0.0) Introduced on the MXL 10/40GbE Switch IO Module.

Commands

ip redirect-list – enables an IP Redirect List.

ip redirect-group

Apply a redirect list (policy-based routing) on an interface. You can apply multiple redirect lists to an

interface by entering this command multiple times.

Syntax

ip redirect-group redirect-list-name

1004

Policy-based Routing (PBR)