Command Line Reference Guide

Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
To access this command, enter the class-map command. You can match against
only one VLAN ID.
Related
Commands
class-map — identifies the class map.
policy-aggregate
Allow an aggregate method of configuring per-port QoS via policy maps. An aggregate QoS policy is part
of the policy map (input/output) applied on an interface.
Syntax
policy-aggregate qos-policy-name
To remove a policy aggregate configuration, use the no policy-aggregate
qos-policy-name command.
Parameters
qos-policy-
name
Enter the name of the policy map in character format (32
characters maximum).
Defaults none
Command
Modes
CONFIGURATION (policy-map-input and policy-map-output)
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Aggregate input/output QoS policy applies to all the port ingoing/outgoing traffic.
Aggregate input/output QoS policy can coexist with per queue input/output QoS
policies.
1. If only aggregate input QoS policy exists, input traffic conditioning
configurations (rate-police) apply. Any marking configurations in aggregate
input QoS policy are ignored.
2. If aggregate input QoS policy and per class input QoS policy coexist,
aggregate input QoS policy preempts per class input QoS policy on input
traffic conditioning (rate-police). In other words, if rate police configuration
exists in the aggregate QoS policy, the rate police configurations in per class
QoS are ignored. Marking configurations in per class input QoS policy still
apply to each queue.
Related
Commands
policy-map-output — creates an output policy map.
1088
Quality of Service (QoS)