Command Line Reference Guide

qos dscp-color-policy
Associates the DSCP color map profile with an interface so that all IP packets received on it is given a
color based on that color map.
Syntax
dscp-color-policy color-map-profile-name
To remove a color policy map profile, use the no dscp-color-policy color-
map-profile-name command.
Parameters
color-map-
profile-name
Enter the color map profile name. The name can have a
maximum of 32 characters.
Defaults None
Command
Modes
CONFIG-INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.5.0.0 Introduced on the Z9000, S6000, S4820T, S4810, and MXL.
Usage
Information
If the specified color-map does not exist, the Diffserv Manager (DSM) creates a
color map and sets all the DSCP values to green (low drop precedence).
Example
The following example assigns the color map, bat-enclave-map, to interface te
0/11.
Dell(conf)# int te 0/11
Dell(conf-if-te-0/11)# qos dscp-color-policy bat-enclave-map
Related
Commands
dscp— sets the number of specific DSCP values for color map profile to yellow or
red.
qos dscp-color-map— configures the DSCP color map.
show qos dscp-color-policy
Display DSCP color policy configuration for one or all interfaces.
Syntax show qos dscp-color-policy {summary [interface] | detail
{interface}}
1110
Quality of Service (QoS)