Command Line Reference Guide

Command
Modes
SPANNING TREE (The prompt is “config-rstp”.)
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
protocol spanning-tree rstp — enters SPANNING TREE mode on the switch.
disable
Disable RSTP globally on the system.
Syntax
disable
To enable Rapid Spanning Tree Protocol, use the no disable command.
Defaults RSTP is disabled.
Command
Modes
CONFIGURATION RSTP (conf-rstp)
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
protocol spanning-tree rstp — enters SPANNING TREE mode on the switch.
forward-delay
Configure the amount of time the interface waits in the Listening State and the Learning State before
transitioning to the Forwarding State.
Syntax
forward-delay seconds
To return to the default setting, use the no forward-delay command.
Parameters
seconds Enter the number of seconds that the system waits before
transitioning RSTP to the forwarding state. The range is from
4 to 30. The default is 15 seconds.
Defaults 15 seconds
Command
Modes
CONFIGURATION RSTP (conf-rstp)
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
1144
Rapid Spanning Tree Protocol (RSTP)