Command Line Reference Guide

protocol spanning-tree rstp
To configure RSTP, enter RSTP mode.
Syntax
protocol spanning-tree rstp
To exit RSTP mode, use the exit command.
Defaults Not configured
Command
Modes
CONFIGURATION
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
RSTP is not enabled when you enter RSTP mode. To enable RSTP globally on the
system, use the no disable command from RSTP mode.
Example
Dell(conf)#protocol spanning-tree rstp
Dell(config-rstp)##no disable
Related
Commands
disable — disables RSTP globally on the system.
show config
View the current configuration for the mode. Only non-default values are displayed.
Syntax
show config
Command
Modes
CONFIGURATION RSTP (conf-rstp)
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell(conf-rstp)#show config
!
protocol spanning-tree rstp
no disable
bridge-priority 16384
Rapid Spanning Tree Protocol (RSTP)
1147