Command Line Reference Guide

sflow enable (Global)
Enable sFlow globally.
Syntax
sflow enable
To disable sFlow, use the no sflow enable command.
Defaults Disabled.
Command
Modes
CONFIGURATION
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
sFlow is disabled by default. In addition to this command, you must enable sFlow
on individual interfaces where you want sFlow sampling.
Related
Commands
sflow enable (Global) — enables sFlow on interfaces.
sflow enable (Interface)
Enable sFlow on interfaces.
Syntax
sflow enable
To disable sFlow, use the no sflow enable command.
Defaults Disabled.
Command
Modes
INTERFACE
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
When you enable sFlow on an interface, flow sampling is done on any traffic going
out of the interface.
NOTE: After a physical port is a member of a LAG, it inherits the sFlow
configuration from the LAG port.
Related
Commands
sflow enable (Global) — turns sFlow on globally.
1210
sFlow