Command Line Reference Guide

global default counter polling (20 seconds) interval. You can configure an interface
to use a different polling interval.
sflow polling-interval (Global)
Set the sFlow polling interval at a global level.
Syntax
sflow polling-interval interval value
To return to the default, use the no sflow polling-interval interval
command.
Parameters
interval value Enter the interval value in seconds. The range is from 15 to
86400 seconds. The default is 20 seconds.
Defaults 20 seconds
Command
Modes
CONFIGURATION
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The polling interval for an interface is the maximum number of seconds between
successive samples of counters sent to the collector. This command changes the
global default counter polling (20 seconds) interval. You can configure an interface
to use a different polling interval.
sflow sample-rate (Global)
Change the global default sampling rate.
Syntax
sflow sample-rate value
To return to the default sampling rate, use the no sflow sample-rate
command.
Parameters
value Enter the sampling rate value. The range is from 256 to
8388608 packets. Enter values in powers of 2 only; for
example, 4096, 8192, 16384, and so on. The default is 32768
packets.
Defaults 32768 packets
Command
Modes
CONFIGURATION
1212
sFlow