Command Line Reference Guide

protocol-tunnel rate-limit
Enable traffic rate limiting per box.
Syntax
protocol-tunnel rate-limit rate
To reset the rate limit to the default, use the no protocol-tunnel rate-limit
rate command.
Parameters
rate Enter the rate in frames per second. The range is from 75 to
3000. The default is 75.
Defaults 75 frames per second.
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell#
Dell#conf
Dell(conf)#protocol-tunnel rate-limit 1000
Dell(conf)#
Related
Commands
show protocol-tunnel — displays tunneling information for all VLANs.
show running-config — displays the current configuration.
show protocol-tunnel
Display protocol tunnel information for all or a specified VLAN-Stack VLAN.
Syntax
show protocol-tunnel [vlan vlan-id]
Parameters
vlan vlan-id (OPTIONAL) Enter the keyword vlan then the VLAN ID to
display information for the one VLAN. The range is from 1 to
4094.
Defaults none
Command
Modes
EXEC
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell#show protocol-tunnel
System Rate-Limit: 75 frames/second
VLAN Protocols Interface
1000 STP,PVST Gi 5/7,Gi 5/6
Service Provider Bridging
1219