Command Line Reference Guide

undebug all
Disable all debug operations on the system.
Syntax
undebug all
Defaults none
Command
Modes
EXEC Privilege
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
virtual-ip
Configure a virtual IP address for the active management interface. You can configure virtual addresses
both for IPv4 independently.
Syntax
virtual-ip {ipv4-address}
Parameters
ipv4-address Enter the IP address of the active management interface in a
dotted decimal format (A.B.C.D.).
Defaults none
Command
Modes
CONFIGURATION
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Each time you issue this command, it replaces the previously configured address of
the same family. The no virtual-ip command takes an address/prefix-length
argument, so that the desired address only is removed. If you enter the no
virtual-ip
command without any specified address, the IPv4 virtual addresses
are removed.
Example
Dell#virtual-ip 10.11.197.99/16
write
Copy the current configuration to either the startup-configuration file or the terminal.
Syntax
write {memory | terminal}
Parameters
memory Enter the keyword memory to copy the current running
configuration to the startup configuration file. This
Control and Monitoring
123