Command Line Reference Guide

Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Syslog messages contain the IP address of the interface used to egress the router.
By configuring the logging source-interface command, the Syslog packets
contain the IP address of the interface configured.
Related
Commands
logging — enables logging to the Syslog server.
logging synchronous
Synchronize unsolicited messages and output.
Syntax
logging synchronous [level level | all] [limit number-of-
buffers]
To disable message synchronization, use the no logging synchronous [level
level | all] [limit number-of-buffers] command.
Parameters
all Enter the keyword all to ensure that all levels are printed
asynchronously.
level level Enter the keyword level then a number as the severity
level. A high number indicates a low severity level and vice
versa. The range is from 0 to 7. The default is 2.
all Enter the keyword all to turn off all.
limit number-
of-buffers
Enter the keyword limit then the number of buffers to be
queued for the terminal after which new messages are
dropped. The range is from 20 to 300. The default is
20.
Defaults Disabled. If enabled without the level or number-of-buffers options specified,
level = 2 and number-of-buffers = 20 are the defaults.
Command
Modes
LINE
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
When you enable logging synchronous, unsolicited messages appear between
software prompts and outputs. Only the messages with a severity at or below the
set level are sent to the console.
If the message queue limit is reached on a terminal line and messages are
discarded, a system message appears on that terminal line. Messages may continue
to appear on other terminal lines.
Simple Network Management Protocol (SNMP) and Syslog
1249