Command Line Reference Guide

redundancy force-failover stack-unit
Force the standby unit in the stack to become the management unit.
Syntax
redundancy force-failover stack-unit
Defaults Not enabled.
Command
Modes
EXEC Privilege
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
reset stack-unit
Reset any designated stack member except the management unit (master unit).
Syntax
reset stack-unit 0–5 hard
Parameters
0–5 Enter the stack member unit identifier of the stack member
to reset.
hard Reset the stack unit if the unit is in a problem state.
Defaults none
Command
Modes
EXEC
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Resetting the management unit is not allowed, and an error message displays if you
try to do so. Resetting is a soft reboot, including flushing the forwarding tables.
Starting with the Dell Networking OS version 7.8.1.0, you can run this command
directly on the stack standby unit (standby master) to reset the standby. You cannot
reset any other unit from the standby unit.
The first two bold lines in the following example show the output of a not allowed
reset action. The third bold line shows the output of a successful reset action.
Example
Dell# show system brief
Stack MAC : 00:1e:c9:f1:00:7b
Reload Type : jump-start [Next boot : normal-reload]
-- Stack Info --
Unit UnitType Status ReqTyp CurTyp Version
Ports
---------------------------------------------------------------
1256
Stacking