Command Line Reference Guide

hello-time — changes the time interval between BPDUs.
portfast bpdufilter default
Enable BPDU Filter globally to filter transmission of BPDU on port fast enabled interfaces.
Syntax
portfast bpdufilter default
To disable global bpdu filter default, use the no edge-port bpdufilter
default command.
Defaults Disabled
Command
Modes
SPANNING TREE
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
protocol spanning-tree
To enable and configure the spanning tree group, enter SPANNING TREE mode.
Syntax
protocol spanning-tree stp-id
To disable the Spanning Tree group, use the no protocol spanning-tree
stp-id command.
Parameters
stp-id Enter zero (0). The system supports one spanning tree group,
group 0.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
STP is not enabled when you enter SPANNING TREE mode. To enable STP globally
on the switch, use the no disable command from SPANNING TREE mode.
Example
Dell(conf)#protocol spanning-tree 0
Dell(config-stp)#
Related
Commands
disable — disables spanning tree group 0. To enable spanning tree group 0, use the
no disable command.
1274
Spanning Tree Protocol (STP)