Command Line Reference Guide

show config
Display the current configuration for the mode. Only non-default values display.
Syntax
show config
Command
Modes
SPANNING TREE
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell(config-stp)#show config
protocol spanning-tree 0
no disable
Dell(config-stp)#
show spanning-tree 0
Display the spanning tree group configuration and status of interfaces in the spanning tree group.
Syntax
show spanning-tree 0 [active | brief | guard | interface
interface | root | summary]
Parameters
0 Enter 0 (zero) to display information about that specific
spanning tree group.
active (OPTIONAL) Enter the keyword active to display only active
interfaces in spanning tree group 0.
brief (OPTIONAL) Enter the keyword brief to display a synopsis
of the spanning tree group configuration information.
guard (OPTIONAL) Enter the keyword guard to display the type of
guard enabled on an STP interface and the current port state.
interface
interface
(OPTIONAL) Enter the keyword interface and the type
slot/port of the interface you want displayed. Type slot/port
options are the following:
• For a Port Channel interface, enter the keywords port-
channel
then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
root (OPTIONAL) Enter the keyword root to display configuration
information on the spanning tree group root.
summary (OPTIONAL) Enter the keyword summary to only the number
of ports in the spanning tree group and their state.
Spanning Tree Protocol (STP)
1275