Command Line Reference Guide

ntp disable
Prevent an interface from receiving NTP packets.
Syntax
ntp disable
To re-enable NTP on an interface, use the no ntp disable command.
Defaults Disabled (that is, if you configure an NTP host, all interfaces receive NTP packets)
Command
Modes
INTERFACE
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
ntp multicast client
To receive NTP information from the network via multicast, configure the switch.
Syntax
ntp multicast client [multicast-address]
To disable multicast reception, use the no ntp multicast client
[
multicast-address] command.
Parameters
multicast-
address
(OPTIONAL) Enter a multicast address. Enter either an IPv4
address in dotted decimal format. If you do not enter a
multicast address, the address 224.0.1.1 is configured if the
interface address is IPv4.
Defaults Not configured.
Command
Modes
INTERFACE
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
ntp server
Configure an NTP time-serving host.
Syntax
ntp server {hostname | ipv4-address} [key keyid] [prefer]
[version number]
Parameters
ipv4-address Enter an IPv4 address (A.B.C.D).
System Time and Date
1289