Command Line Reference Guide

56
u-Boot
All commands in this chapter are in u-Boot mode. These commands are supported on the Dell
Networking Operating System (OS) MXL 10/40GbE Switch Module platform.
To access this mode, press any key when the following line appears on the console during a system boot.
Hit any key to stop autoboot:
Enter u-Boot immediately, as the BOOT_USER# prompt.
NOTE: This chapter describes only a few commands available in u-Boot mode.
NOTE: You cannot use the Tab key to complete commands in this mode.
boot change
Change the operating system boot parameters.
Syntax
boot change [primary | secondary | default]
Command
Modes
uBoot
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
boot selection
Change the ROM bootstrap bootflash partition.
Syntax
boot selection [a | b]
Command
Modes
uBoot
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
1304
u-Boot