Command Line Reference Guide

Related
Commands
dei mark — sets the DEI value on egress.
vlan-stack access
Specify a Layer 2 port or port channel as an access port to the stackable VLAN network.
Syntax
vlan-stack access
To remove access port designation, use the no vlan-stack access command.
Defaults Not configured.
Command
Modes
INTERFACE
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Prior to enabling this command, to place the interface in Layer 2 mode, enter the
switchport command.
To remove the access port designation, remove the port (using the no member
interface command) from all stackable VLAN enabled VLANs.
vlan-stack compatible
Enable the stackable VLAN feature on a VLAN.
Syntax
vlan-stack compatible
To disable the Stackable VLAN feature on a VLAN, use the no vlan-stack
compatible
command.
Defaults Not configured.
Command
Modes
CONF-IF-VLAN
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Prior to disabling the stackable VLAN feature, remove the members.
To view the stackable VLANs, use the show vlan command in EXEC Privilege
mode. Stackable VLANs contain members, designated by the M in the Q column of
the command output.
1326
VLAN Stacking