Command Line Reference Guide

primary-priority
Reconfigure the primary role of VLT peer switches.
Syntax
primary-priority value
Parameters
value To configure the primary role on a VLT peer, enter a lower
value than the priority value of the remote peer. The range is
from 1 to 65535.
Default 32768
Command
Modes
VLT DOMAIN
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
After you configure the VLT domain on each peer switch on both sides of the
interconnect trunk, by default, the software elects a primary and secondary VLT
peer device. To reconfigure the primary role of VLT peer switches, use the
priority command.
show ip mroute
View the multicast routing table.
Syntax
show ip mroute [static | group-address [source-address] | count
| snooping [vlan vlan-id] [group-address [source-address]] |
summary | vlt [group-address | count]
Parameters
Static (OPTIONAL) Enter the keyword static to view static
multicast routes.
group-address
[source-
address]
(OPTIONAL) Enter the multicast group-address to view only
routes associated with that group.
Enter the source-address to view routes with that group-
address and source-address.
count (OPTIONAL) Enter the keyword count to view the number of
multicast routes and packets.
snooping [vlan
vlan-id]
[group-address
[source-
address]]
(OPTIONAL)
Enter the keyword snooping to display information on the
multicast routes PIM-SM snooping discovers.
Enter a VLAN ID to limit the information displayed to the
multicast routes PIM-SM snooping discovers on a specified
VLAN. The VLAN ID range is from 1 to 4094.
Virtual Link Trunking (VLT)
1335