Command Line Reference Guide

value (in seconds) is based on the configured RADIUS-server timeout and
retransmit values and calculated according to the following formula: dot1x
server-timeout seconds > (radius-server retransmit seconds + 1) * radius-server
timeout
seconds.
Where the default values are as follows: dot1x server-timeout (30 seconds),
radius-server retransmit (3 seconds), and radius-server timeout (5 seconds).
For example:
Dell(conf)#radius-server host 10.11.197.105 timeout 6
Dell(conf)#radius-server host 10.11.197.105 retransmit 4
Dell(conf)#interface gigabitethernet 2/23
Dell(conf-if-gi-2/23)#dot1x server-timeout 40
dot1x supplicant-timeout
Configure the amount of time after which exchanges with the supplicant time-out.
Syntax
dot1x supplicant-timeout seconds
To return to the default, use the no dot1x supplicant-timeout command.
Parameters
seconds Enter a time-out value in seconds. The range is from 1 to
300, where 300 is implementation dependant. The default is
30.
Defaults 30 seconds
Command
Modes
INTERFACE
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
dot1x tx-period
Configure the intervals at which EAPOL PDUs the Authenticator PAE transmits.
Syntax
dot1x tx-period seconds
To return to the default, use the no dot1x tx-period command.
Parameters
seconds Enter the interval time, in seconds, that EAPOL PDUs are
transmitted. The range is from 1 to 65535. The default is 30.
134
802.1X