Command Line Reference Guide

dcbmapABC te 0/1 Active
dcbmapXYZ te 0/2 Not active
Dell# show dcb-map dcbmapABC
Priority-Group Table:
Priority-Group Priorities Bandwidth(%)
0 0,1,2,5,6,7 50
1 3 30
2 4 20
3 -
5 -
6 -
7 -
PFC Enabled priorities: 3, 4
Related
Commands
dcb-map — creates a DCB map to configure DCB parameters on Ethernet ports
that support converged Ethernet traffic.
show qos dcb-map
Display the DCB parameters configured in a specified DCB map.
FC Flex IO Modules with MXL
Syntax
show qos dcb-map map-name
Parameters
map-name Displays the PFC and ETS parameters configured in the
specified map.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.3(0.0) Introduced on the FC Flex IO module installed in the MXL
10/40GbE Switch.
Usage
Information
Use the show qos dcb-map command to display the enhanced transmission
selection (ETS) and priority-based flow control (PFC) parameters used to configure
server-facing Ethernet ports.
The following table describes the show qos dcb-map output shown in the
example below.
Field Description
State Complete: All mandatory DCB parameters are correctly
configured. In progress: The DCB map configuration is not
complete. Some mandatory parameters are not configured.
PFC Mode PFC configuration in DCB map: On (enabled) or Off.
PG Priority group configured in the DCB map.
1376
FC Flex IO Modules