Command Line Reference Guide

ManualsBrandsDell ManualsSoftwareForce10

1411

module FC ports so that they appear to downstream server CNA ports as FCoE

Forwarder (FCF) ports on an FCoE network.

The following table describes the show fcoe-map brief output shown in the

example below.

Field Description

Fabric-Name Name of a SAN fabric.

Fabric ID The ID number of the SAN fabric to which FC traffic is

forwarded.

VLAN ID The dedicated FCoE VLAN used to transport FCoE storage

traffic between servers and a fabric over the NPIV proxy

gateway. The configured VLAN ID must be the same as the

fabric ID.

FC-MAP FCoE MAC address-prefix value - The unique 24-bit MAC

address prefix that identifies a fabric.

FCF Priority The priority used by a server to select an upstream FCoE

forwarder.

Config-State Indicates whether the configured FCoE and FC parameters

in the FCoE map are valid: Active (all mandatory FCoE and

FC parameters are correctly configured) or Incomplete

(either the FC-MAP value, fabric ID, or VLAN ID are not

correctly configured).

Oper-State Operational status of link to the fabric: Up (link is up and

transmitting FC traffic), Down (link is down and not

transmitting FC traffic), Link-wait (link is up and waiting for

FLOGI to complete on peer FC port), or Removed (port has

been shut down).

The following table describes the show fcoe-map map-name output shown in

the example below.