Command Line Reference Guide

Related
Commands
• priority-list — configures the 802.1p priorities for an ETS output policy.
• set-pgid — configures the priority-group.
priority-group qos-policy
Associate the 802.1p priority traffic in a priority group with the ETS configuration in a QoS output policy.
Syntax
priority-group group-name qos-policy ets-policy-name
To remove the 802.1p priority group, use the no priority-group qos-policy
command.
Parameters
group-name Enter the group name of the 802.1p priority group. The
maximum is 32 characters.
ets-policy-
name
Enter the ETS policy name.
Defaults none
Command
Modes
DCB OUTPUT POLICY
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The ETS configuration associated with 802.1p priority traffic in a DCB output policy
is used in DCBX negotiation with ETS peers.
If you disable ETS in an output policy applied to an interface using the no ets
mode on
command, any previously configured QoS settings at the interface or
global level take effect. If you configure QoS settings at the interface or global level
and in an output policy map (the service-policy output command), the QoS
configuration in the output policy takes precedence.
NOTE: Please note that Dell Networking does not recommended to use this
command as it has been deprecated in the current 9.4(0.0) release. A warning
message appears when you try to run this command indicating that you have
to use the dcb-map commands in the future.
Related
Commands
• dcb-output — creates a DCB output policy.
• dcb-policy output — applies the output policy.
PMUX Mode of the MXL 10/40GbE Switch I/O Module
1439