Command Line Reference Guide

{summary |
detail}
Enter the keyword summary for a summary list of results or
enter the keyword detail for a full list of results.
Command
Modes
INTERFACE
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
To clear the PFC TLV counters, use the clear pfc counters interface
port-type slot/port command.
The following describes the show interface pfc summary command shown in
the following example.
Field Description
Interface Interface type with stack-unit and port number.
Admin mode is on
Admin is enabled
PFC admin mode is on or off with a list of the configured
PFC priorities. When the PFC admin mode is on, PFC
advertisements are enabled to be sent and received from
peers; received PFC configuration take effect. The admin
operational status for a DCBX exchange of PFC
configuration is enabled or disabled.
Remote is
enabled, Priority
list Remote
Willing Status is
enabled
Operational status (enabled or disabled) of peer device for
DCBX exchange of PFC configuration with a list of the
configured PFC priorities. Willing status of peer device for
DCBX exchange (Willing bit received in PFC TLV): enabled or
disable.
Local is enabled DCBX operational status (enabled or disabled) with a list of
the configured PFC priorities.
Operational status
(local port)
Port state for current operational PFC configuration:
• Init: Local PFC configuration parameters were
exchanged with the peer.
• Recommend: Remote PFC configuration parameters
were received from the peer.
• Internally propagated: PFC configuration
parameters were received from the configuration
source.
PFC DCBX Oper
status
Operational status for the exchange of the PFC
configuration on the local port: match (up) or mismatch
(down).
1450
PMUX Mode of the MXL 10/40GbE Switch I/O Module