Command Line Reference Guide

--------------------------------------------------------
0 0 0 0
1 0 0 0
2 0 0 0
3 0 0 0
4 0 0 0
5 0 0 0
6 0 0 0
7 0 0 0
show qos dcb-input
Displays the PFC configuration in a DCB input policy.
Syntax
show qos dcb-input [pfc-profile]
Parameters
pfc-profile Enter the PFC profile.
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
NOTE: Please note that Dell Networking does not recommended to use this
command as it has been deprecated in the current 9.4(0.0) release. A warning
message appears when you try to run this command indicating that you have
to use the dcb-map commands in the future.
Example
Dell(conf)# show qos dcb-input
dcb-input pfc-profile
pfc link-delay 32
pfc priority 0-1
dcb-input pfc-profile1
no pfc mode on
pfc priority 6-7
show qos dcb-output
Displays the ETS configuration in a DCB output policy.
Syntax
show qos dcb-output [ets-profile]
Parameters
[ets-profile] Enter the ETS profile.
Command
Modes
EXEC Privilege
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
PMUX Mode of the MXL 10/40GbE Switch I/O Module
1453