Command Line Reference Guide

off on
on off
on on
LocNegRx LocNegTx RemNegRx RemNegTx
off off off off
off off off off
off off off off
off off off off
off off off off
off off off off
off on on off
off off off off
off off off off
on off off on
on on on on
on on on on
off off off off
off off off off
on on on on
on on on on
Related
Commands
show running-config — displays the flow configuration parameters (non-default
values only).
show interfaces — displays the negotiated flow control parameters.
interface
Configure a physical interface on the switch.
Syntax
interface interface
Parameters
interface Enter one of the following keywords and slot/port or number
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Fibre Channel interface, enter the keyword
FibreChannel, then the slot/port information.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
Version 9.4(0.0) Added the support for interfaces.
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
PMUX Mode of the MXL 10/40GbE Switch I/O Module
1467