Command Line Reference Guide

lacp port-priority
To influence which ports will be put in Standby mode when there is a hardware limitation that prevents all
compatible ports from aggregating, configure the port priority.
Syntax
lacp port-priority priority-value
To return to the default setting, use the no lacp port-priority priority-
value command.
Parameters
priority-value Enter the port-priority value. The higher the value number,
the lower the priority. The range is from 1 to 65535. The
default is 32768.
Defaults 32768
Command
Modes
INTERFACE
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
port-channel mode
Configure the LACP port channel mode.
Syntax
port-channel number mode [active] [passive] [off]
Parameters
number Enter the keywords number then a number.
active Enter the keyword active to set the mode to the active
state.
NOTE: LACP modes are defined in Usage Information.
passive Enter the keyword passive to set the mode to the passive
state.
NOTE: LACP modes are defined in Usage Information.
off Enter the keyword off to set the mode to the off state.
NOTE: LACP modes are defined in Usage Information.
Defaults off
Command
Modes
INTERFACE
1494
PMUX Mode of the MXL 10/40GbE Switch I/O Module