Command Line Reference Guide

--------- ------------ -----------
100 -- L3
Vlan IPV4 Multicast Status
--------------------------
Vlan-ID Local Status Peer Status
-------- ------------ -----------
4094 Active Inactive
Dell#
system-mac
Reconfigure the default MAC address for the domain.
Syntax
system-mac mac-address
Parameters
mac-address Enter the system MAC address for the VLT domain.
Defaults Not configured.
Command
Modes
VLT DOMAIN
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 9.0.0.0 Introduced on the Z9000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.8.0 Introduced on the S4810.
Usage
Information
When you create a VLT domain on a switch, Dell Networking OS automatically
creates a VLT-system MAC address used for internal system operations.
To reconfigure the default MAC address for the domain by entering a new MAC
address in the format nn:nn:nn:nn:nn:nn, use the system-mac command.
You must also reconfigure the same MAC address on the VLT peer switch.
unit-id
Explicitly configure the default unit ID of a VLT peer switch.
Syntax
unit-id [0 | 1]
PMUX Mode of the MXL 10/40GbE Switch I/O Module
1515