Command Line Reference Guide

ManualsBrandsDell ManualsSoftwareForce10

1531

Version

8.3.19.0

Introduced on the S4820T.

Version 8.3.11.1 Introduced on the Z9000.

Version 8.3.7.0 Introduced on the S4810.

Version 7.6.1.0 Introduced on the S-Series.

Version 7.5.1.0 Introduced on the C-Series.

E-Series legacy

command

Commands

show logging — displays logging settings and system messages in the internal

buffer.

logging

Configure an IP address or host name of a Syslog server where logging messages are sent. Multiple

logging servers of both IPv4 and/or IPv6 can be configured.

Syntax

logging {ip-address | ipv6-address | hostname} [vrf vrf-name]

To disable logging, use the no logging command.

Parameters

ip-address Enter the IPv4 address in dotted decimal format.

ipv6-address Enter the IPv6 address in the x:x:x:x::X format.

NOTE: The :: notation specifies successive hexadecimal

fields of zeros.

hostname Enter the name of a host already configured and recognized

by the switch.

Defaults Disabled.

Command

Modes

CONFIGURATION

Command

History

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is

supported in Programmable-Mux (PMUX) mode only.