Command Line Reference Guide

match metric
To match on a specified value, configure a filter.
Syntax
match metric metric-value
Parameters
metric-value Enter a value to match. The range is from zero (0) to
4294967295.
Defaults Not configured.
Command
Modes
ROUTE-MAP
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
match interface — redistributes routes that match the next-hop interface.
match ip address — redistributes routes that match an IP address.
match ip next-hop — redistributes routes that match the next-hop IP address.
match ip route-source — redistributes routes that match routes advertised by other
routers.
match route-type — redistributes routes that match a route type.
match tag — redistributes routes that match a specific tag.
match route-type
To match routes based on the how the route is defined, configure a filter.
Syntax
match route-type {external [type-1 | type-2] | internal |
local}
Parameters
external
[type-1| type-2]
Enter the keyword external then either type-1 or type-2 to
match only on OSPF Type 1 routes or OSPF Type 2 routes.
internal Enter the keyword internal to match only on routes
generated within OSPF areas.
local Enter the keyword local to match only on routes generated
within the switch.
Defaults Not configured.
Command
Modes
ROUTE-MAP
Access Control Lists (ACL)
205