Command Line Reference Guide

multiplier value Enter the keywords multiplier to specify the number of
packets that must be missed in order to declare a session
down. The range is from 3 to 50. The default is 3.
role [active |
passive]
Enter the role that the local system assumes:
• Active — The active system initiates the BFD session.
Both systems can be active for the same session.
• Passive — The passive system does not initiate a
session. It only responds to a request for session
initialization from the active system.
The default is Active.
Defaults See Parameters
Command
Modes
CONFIGURATION
Command
History
Version 9.2.
(0.0)
Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
show bfd neighbors — displays the BFD neighbor information on all interfaces or a
specified interface.
ipv6 ospf bfd all-neighbors
Establish BFD sessions with all OSPFv3 neighbors on a single interface or use non-default BFD session
parameters.
Syntax
ipv6 ospf bfd all-neighbors [disable | [interval interval
min_rx min_rx multiplier value role {active | passive}]]
To disable all BFD sessions on an OSPFv3 interface implicitly, use the no ipv6
ospf bfd all-neighbors [disable | [interval interval min_rx
min_rx multiplier value role {active | passive}]]command in
interface mode..
Parameters
disable (OPTIONAL) Enter the keyword disable to disable BFD on
this interface.
interval
milliseconds
(OPTIONAL) Enter the keyword interval to specify non-
default BFD session parameters beginning with the
transmission interval. The range is from 50 to 1000. The
default is
100.
min_rx
milliseconds
Enter the keywords min_rx to specify the minimum rate at
which the local system receives control packets from the
remote system. The range is from 50 to 100. The default is
100.
Bidirectional Forwarding Detection (BFD)
303