Command Line Reference Guide

neighbor local-as
To accept external routes from neighbors with a local AS number in the AS number path, configure
Internal BGP (IBGP) routers.
Syntax
neighbor {ip-address | peer-group-name} local-as as-number [no-
prepend]
To return to the default value, use the no neighbor {ip-address | peer-
group-name} local-as command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal
format.
peer-group-
name
Enter the name of the peer group to set the advertisement
interval for all routers in the peer group.
as-number Enter the AS number to reset all neighbors belonging to that
AS. The range is from 0 to 65535 (2 byte), from 1 to
4294967295 (4 byte) or from 0.1 to 65535.65535 (dotted
format).
no prepend Specifies that local AS values do not prepend to
announcements from the neighbor.
Defaults Not configured.
Command
Modes
ROUTER BGP
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
bgp four-octet-as-support — enables 4-byte support for the BGP process.
neighbor maximum-prefix
Control the number of network prefixes received.
Syntax
neighbor {ip-address | peer-group-name} maximum-prefix maximum
[threshold] [warning-only]
To return to the default values, use the no neighbor {ip-address | peer-
group-name} maximum-prefix maximum command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal
format.
peer-group-
name
Enter the name of the peer group.
Border Gateway Protocol IPv4 (BGPv4)
345