Command Line Reference Guide

To stop redistribution of OSPF routes, use the no redistribute ospf
process-id command.
Parameters
process-id Enter the number of the OSPF process. The range is from 1
to 65535.
match external
{1 | 2}
(OPTIONAL) Enter the keywords match external to
redistribute OSPF external routes. You can specify 1 or 2 to
redistribute those routes only.
match internal (OPTIONAL) Enter the keywords match internal to
redistribute OSPF internal routes only.
route-map
map-name
(OPTIONAL) Enter the keywords route-map then the name
of a configured route map.
Defaults Not configured.
Command
Modes
ROUTER BGP
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
With the Dell Networking OS version 8.3.1.0 and later, you can use the
redistribute command to advertise the IGP cost as the MED on redistributed
routes. When you set the route-map with metric-type internal and apply outbound
to an EBGP peer/peer-group, the advertised routes corresponding to those peer/
peer-groups have the IGP cost set as
MED.
When you enter the redistribute isis process-id command without any
other parameters, the system redistributes all OSPF internal routes, external type 1
routes, and external type 2 routes. RFC does not support this feature.
router bgp
To configure and enable BGP, enter ROUTER BGP mode.
Syntax
router bgp as-number
To disable BGP, use the no router bgp as-number command.
Parameters
as-number Enter the AS number. The range is from 1 to 65535 (2 byte),
from 1 to 4294967295 (4 byte), or from 0.1 to 65535.65535
(dotted format).
Defaults Not enabled.
360
Border Gateway Protocol IPv4 (BGPv4)