Command Line Reference Guide

1239 13716 i
*> 63.114.8.33 0 18508 701
1239 13716 i
* 4.21.132.0/23 63.114.8.33 0 18508 209
6461 16422 i
*> 63.114.8.33 0 18508 701
6461 16422 i
*> 4.24.118.16/30 63.114.8.33 0 18508 209 i
*> 4.24.145.0/30 63.114.8.33 0 18508 209 i
*> 4.24.187.12/30 63.114.8.33 0 18508 209 i
*> 4.24.202.0/30 63.114.8.33 0 18508 209 i
*> 4.25.88.0/30 63.114.8.33 0 18508 209
3561 3908 i
*> 5.0.0.0/9 63.114.8.33 0 0 18508 ?
*> 5.0.0.0/10 63.114.8.33 0 0 18508 ?
*> 5.0.0.0/11 63.114.8.33 0 0 18508 ?
--More--
Related
Commands
show ip bgp community — views the BGP communities.
neighbor maximum-prefix — controls the number of network prefixes received.
show ip bgp cluster-list
View BGP neighbors in a specific cluster.
Syntax
show ip bgp [ipv4 unicast] cluster-list [cluster-id]
Parameters
ipv4 unicast (OPTIONAL) Enter the keywords ipv4 unicast to view
information only related to ipv4 unicast routes.
cluster-id (OPTIONAL) Enter the cluster id in dotted decimal format.
The range is 1 — 4294967295.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The following describes the show ip bgp cluster-list command shown in
the following example.
Field Description
Network Displays the destination network prefix of each BGP route.
Next Hop Displays the next hop address of the BGP router. If 0.0.0.0 is
listed in this column, then local routes exist in the routing
table.
364
Border Gateway Protocol IPv4 (BGPv4)