Command Line Reference Guide

summary (OPTIONAL) Enter the keyword summary to view status
information of the peers in that peer group. The output is the
same as that found in the show ip bgp summary
command.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The following describes the show ip bgp peer-group command shown in the
following example.
Line beginning
with:
Description
Peer-group Displays the peer group’s name.
Administratively
shut
Displays the peer group’s status if the peer group is not
enabled. If you enable the peer group, this line is not
displayed.
BGP version Displays the BGP version supported.
Minimum time Displays the time interval between BGP advertisements.
For address family Displays IPv4 Unicast as the address family.
BGP neighbor Displays the name of the BGP neighbor.
Number of peers Displays the number of peers currently configured for this
peer group.
Peer-group
members:
Lists the IP addresses of the peers in the peer group. If the
address is outbound optimized, an * is displayed next to the
IP address.
Example
(S4810 S4820T)
Dell#show ip bgp peer-group
Peer-group pg1
BGP version 4
Minimum time between advertisement runs is 30 seconds
For address family: IPv4 Unicast
BGP neighbor is pg1
Number of peers in this group 4
Update packing has 4_OCTECT_AS support enabled
Add-path support enabled
Peer-group members (* - outbound optimized):
1.1.1.5
1.1.1.6
10.10.10.2*
20.20.20.100
386
Border Gateway Protocol IPv4 (BGPv4)