Command Line Reference Guide

show ip bgp dampened-paths
View BGP routes that are dampened (non-active).
Syntax
show ip bgp [ipv4 unicast] dampened-paths
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The following describes the show ip bgp damp command shown in the
following example.
Field Description
Network Displays the network ID to which the route is dampened.
From Displays the IP address of the neighbor advertising the
dampened route.
Reuse Displays the hour:minutes:seconds until the dampened
route is available.
Path Lists all the ASs the dampened route passed through to
reach the destination network.
Example
Dell>show ip bgp dampened-paths
BGP table version is 210708, local router ID is 63.114.8.2
Status codes: s suppressed, d damped, h history, * valid, >
best
Path source: I - internal, a - aggregate, c - confed-external,
r - redistributed, n - network
Origin codes: i - IGP, e - EGP, ? - incomplete
Network From Reuse Path
Dell>
BGP Extended Communities (RFC 4360)
BGP Extended Communities, as defined in RFC 4360, is an optional transitive BGP attribute.
BGP Extended Communities provides two major advantages over Standard Communities:
• The range is extended from 4-octet (AA:NN) to 8-octet (Type:Value) to provide enough number
communities.
• Communities are structured using a new “Type” field (1 or 2-octets), allowing you to provide granular
control/filter routing information based on the type of extended communities.
394
Border Gateway Protocol IPv4 (BGPv4)