Command Line Reference Guide

fcoeacl
number
Enter the keyword fcoeacl and then the number of FP
blocks for FCOE ACL. The range is from 0 to 6.
Iscsioptacl
number
Enter the keyword iscsioptacl and then the number of FP
blocks for iSCSI optimization ACL. The range is from 0 to 2.
vrfv4acl
number
Enter the keyword vrfv4acl and then the number of FP
blocks for VRF IPv4 ACL. The range is from 0 to 2.
NOTE: Use this attribute to specify the number of VRF
ACL groups. The total number of VRF ACL groups should
not exceed 13. You can assign only one VRF ACL group
with an odd numbered value.
l2acl number
ipv4acl number
ipv6acl
number,
ipv4qos
number l2qos
number, l2pt
number
ipmacacl
number
ecfmacl
number [vman-
qos | vman--
qos-dual
number |
vman-qos-
dual-fp
number]
ipv4pbr
number
Allocate space to each CAM region.
Enter the CAM profile name then the amount of CAM space
to be allotted. The total space allocated must equal 13. The
range for ipv4acl is from 1 to 4. The ipv6acl range must be a
factor of 2.
The total space allocated must equal 13.
The range for ipv4acl is 1 to 4.
The ipv6acl range must be a factor of 2.
The vman-qos-dual-fp number must be entered as a
multiple of 4.
Command
Modes
CONFIGURATION
Command
History
Version 9.4.
(0.0)
Added support for PBR.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Save the new CAM settings to the startup-config (write-mem or copy run
start
) then reload the system for the new settings to take effect.
The total amount of space allowed is 16 FP Blocks. System flow requires three
blocks; these blocks cannot be reallocated. The ipv4acl profile range is from 1 to
4.
When configuring space for IPv6 ACLs, the total number of Blocks must equal 13.
Content Addressable Memory (CAM)
405