Command Line Reference Guide

On the MXL 10/40GbE switch IO module, there can be only one odd number of
Blocks in the CLI configuration; the other Blocks must be in factors of two. For
example, a CLI configuration of 5+4+2+1+1 Blocks is not supported; a
configuration of 6+4+2+1 Blocks is supported.
Ranges for the CAM profiles are from 1 to 10, except for the ipv6acl profile which
is from 0 to 10. The ipv6acl allocation must be a factor of two (2, 4, 6, 8, 10).
cam-optimization
Optimize CAM utilization for QoS Entries by minimizing require policy-map CAM space.
Syntax
cam-optimization [qos]
Parameters
qos Optimize CAM usage for QoS.
Defaults Disabled.
Command
Modes
CONFIGURATION
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
When you enable this command, if a Policy Map containing classification rules (ACL
and/or dscp/ ip-precedence rules) is applied to more than one physical interface
on the same port pipe, only a single copy of the policy is written (only one FP entry
is used).
NOTE: An ACL itself may still require more that a single FP entry, regardless of
the number of interfaces. For more information, refer to the IP Access Control
Lists, Prefix Lists, and Route-mapsections in the Dell Operating System
Configuration Guide.
show cam-acl
Display the details of the CAM profiles on the chassis and all stack units.
Syntax
show cam-acl
Defaults none
Command
Modes
EXEC Privilege
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
406
Content Addressable Memory (CAM)