Command Line Reference Guide

priority-list
Configure the 802.1p priorities for the traffic on which you want to apply an ETS output policy.
Syntax
priority-list value
To remove the priority list, use the no priority-list command.
Parameters
value Enter the priority list value. Separate priority values with a
comma; specify a priority range with a dash; for example,
priority-list 3,5-7. The range is from 0 to 7.
Defaults none
Command
Modes
PRIORITY-GROUP
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
By default:
• All 802.1p priorities are grouped in priority group 0.
• 100% of the port bandwidth is assigned to priority group 0. The complete
bandwidth is equally assigned to each priority class so that each class has 12 to
13%.
NOTE: Please note that Dell Networking does not recommended to use
this command as it has been deprecated in the current 9.4(0.0) release. A
warning message appears when you try to run this command indicating
that you have to use the dcb-map commands in the future.
Related
Commands
• priority-group qos-policy — associates an ETS priority group with an ETS
output policy.
• set-pgid — configures the priority-group.
qos-policy-output ets
To configure the ETS bandwidth allocation and scheduling for priority traffic, create a QoS output policy.
Syntax
qos-policy-output policy-name ets
To remove the QoS output policy, use the no qos-policy-output ets
command.
Parameters
policy-name Enter the policy name. The maximum is 32 characters.
Data Center Bridging (DCB)
437